The Lost Mini Driver surfboard is a great bigger wave surfboard that can be ridden shorter by a few inches than your traditional shortboard. This board has a slightly flatter rocker with a pulled in tail so it can handle the 2' slop and the macking barrels. Here is details about the surfboard as described by shaper Matt Biolos. Mini Driver – While preparing a quiver for an Indo trip Kolohe asked for “a short, fast (flat rockered) little 5 fin tube rider”. I recommended the Rock-Up, but he felt it had more tail rocker than he liked and wanted something really, really fast that he could take off extremely deep and pump through tubes from way back. We started with a 6’0” Driver, took note of the nose rocker and outline measurements at 4” and 16” back from the tip, then shrunk the board to a 5’8” and lowered the nose rocker at the tip and 12” back till it matched the 4” and 16” from before. We widened the nose until it matched up the same way. This gave us a screaming fast low nose rocker with a forward placed outline, both attributes give tons of drive. We then rounded off the tail, but left the width at 12” the same. This gave us a very clean and elliptical outline that we expected would move free and easy inside the tube. The Mini Driver performed as hoped. Interestingly enough, one of Kolohe’s buddies (Taylor Clark) grabbed it after it came back from Indo and used it in the US Nationals event in Huntington Beach. He surfed it in 2’ slop all the way to a second place finish in the Open Men’s division. The board worked in everything.

Lost Mini Driver Details:

6'4 x 21" x 2.75"
37.65 Cubic Liters
Future Fins/5 fin setup
3-7 foot surf Learn More

The Lost Lay-Z boy surfboard is both a continuation and a break away from the Bottom Feeder and Plank Genre surfboards. The Lay-Zboy takes these high volume low rocker small wave surfboard designs and brings it to a wider range of surf capabilities. This surfboard uses an eliptical outline influenced by Wayne Lynch & Michael Peterson in the 1970's as well as Dave Parmenter in the 80's and 90's. These eliptical outlines give the Lay-Zboy a very open and forgiving sweet spot and allow the board to be surfed in knee to well overhead waves.

Lost Lay-Zboy details:
5'11 x 21.75 x 2.69
39.52 cubic litres
Future 5 fin set up
Learn More

Lost 5'11 Pelagic Fish Surfboard:

In surfboards, everything is balance. Curvy rockers need to balance with straighter outlines and curvy outlines need flatter rockers. These principles became very apparent in the development of the Pelagic. Beginning with a fairly standard RNF template, we added a point at 12” from the tail and carved a reverse, side-cut, outline from there forward, into the wide point just above center. This effectively creates a reversed curve outline between the riders stance. To balance the negative outline curve, we have added a tremendous amount of rail rocker through the center of the board. The final component is very low, straight and fast centerline rocker, which cuts a massively deep concave through the rail rocker.

Details:

• 5'11 x 20.75 x 2.5


• Future 5-Fin


• 34.42 Cubic Liters

Learn More

Derived from the Whiplash-TB. The TB-Stepdown is more of an “every-mans” high performance shortboard. Used by many WT and Qualifying Series competitors, because it works equally well in small junk surf. Featuring the Same WL-TB, hyper extended tail rocker (for tight radius arcs off the back foot) but a significantly more relaxed entry rocker, which combined with a wider nose allows for more drive and forward momentum , and stability, with a bigger landing platform from reverse and tweaked airs. A wider hip and tail block is added to the outline in the tail for more lift at low speeds, but the tail width at 12” is relatively the same as the WL- TB. This allows for superior precision and control than most al other “grovel” boards. With the centerline and rail volume is carried farther into the rails….and out to nose and tail the TB-stepdown is designed to be ridden 1-2” shorter than the WLashTB. In the right size, this is a HP shortboard that can be ridden and enjoyed by most surfers.



Lost Taj Burrow Beach Buggy Details:


6'4 x 19.75" x 2.63"


FCS Fins


34.27 Cubic Litres Learn More

Derived from the Whiplash-TB. The TB-Stepdown is more of an “every-mans” high performance shortboard. Used by many WT and Qualifying Series competitors, because it works equally well in small junk surf. Featuring the Same WL-TB, hyper extended tail rocker (for tight radius arcs off the back foot) but a significantly more relaxed entry rocker, which combined with a wider nose allows for more drive and forward momentum , and stability, with a bigger landing platform from reverse and tweaked airs. A wider hip and tail block is added to the outline in the tail for more lift at low speeds, but the tail width at 12” is relatively the same as the WL- TB. This allows for superior precision and control than most al other “grovel” boards. With the centerline and rail volume is carried farther into the rails….and out to nose and tail the TB-stepdown is designed to be ridden 1-2” shorter than the WLashTB. In the right size, this is a HP shortboard that can be ridden and enjoyed by most surfers.

Lost Taj Burrow Beach Buggy Details:

5'11 x 19" x 2.32"
FCS Fins
27.81 Cubic Litres Learn More

Designed to be ridden 2-4” longer than you would a Rocket. The low entry rocker, flat deck and tapered rails (with a full forward outline) paddles through crowds and moving water, and catches waves with ease. The pulled in tail, combined with the aggressive tail rocker and a smoother, shallower concave, allows controlled maneuvers at high speeds on chest high to double overhead waves

Board Details:

6'4 x 20 x 2.63

FCS Fins

36.99 cL Learn More

Designed to be ridden 2-4” longer than you would a Rocket. The low entry rocker, flat deck and tapered rails (with a full forward outline) paddles through crowds and moving water, and catches waves with ease. The pulled in tail, combined with the aggressive tail rocker and a smoother, shallower concave, allows controlled maneuvers at high speeds on chest high to double overhead waves

Board Details:

6'4 x 20 x 2.63

FCS Fins

36.27 cL Learn More

The world's all-time best selling fish model surfboard. During the filming of 5'5" REDUX, the RNF and RNF Quad were updated and fine tuned. The nose has gotten wider again, and more conservative overall rocker and less concave make for a board that will hold speed in flats and produce harder, longer carves.

A longer, less pronounced vee in the tail gives a more predictable feel out of turns, and a straighter outline adds drive and hold. The deep wing, influenced by MR's vintage twin fins, adds more control of high speeds and better bite in snaps and out of carves. It still paddles great, still makes you look good, but the updates allow harder, more powerful carving turns and a wider range of performance in more varied surf.

Enjoy playing with a multitude of fin setups. The RNF is designed as a twin with rear trailer, but works great as a pure twin fin or try all three standard thrusters for different feels in different conditions. ...Everyone should own one.

Lost Round Nose Fish Surfboard Details:

• 5'11 x 20" x 2.42"


• 33.77 Cubic Litres


• Future 5 Fin


• Wave Height 1-6'

Learn More

The Lost Sub Scorcher 2 surfboard is a fresh twist on the extremely popular Sub Scorcher model. The Vee bottom was removed from the last 6" of the tail which increases the rocker by about  a 1/4" still keeping the rail line static. As a result the board surfs looser for better vertical and pocket surfing. To keep the board fast with losts of drive Lost straightened the outline in the tail by adding the double wing swallow tail. This is a great everyman's daily average wave shortboard.

Lost Sub Scorcher 2 Details:

• 6'4 x 20.75" x 2.75"


• 39.38 Cubic Litres


• FCS Fins


• 2-5 foot surf

Learn More

Lost 5'11 Pelagic Fish Surfboard:

In surfboards, everything is balance. Curvy rockers need to balance with straighter outlines and curvy outlines need flatter rockers. These principles became very apparent in the development of the Pelagic. Beginning with a fairly standard RNF template, we added a point at 12” from the tail and carved a reverse, side-cut, outline from there forward, into the wide point just above center. This effectively creates a reversed curve outline between the riders stance. To balance the negative outline curve, we have added a tremendous amount of rail rocker through the center of the board. The final component is very low, straight and fast centerline rocker, which cuts a massively deep concave through the rail rocker.

Details:

• 5'11 x 20.75 x 2.5


• FCS 5-Fin


• 34.42 Cubic Liters

Learn More

This Lost Surfboard is Kolohe Andino's small wave groveling surfboard model. This surfboard is a blend of Lost's Scorcher and SD2 model shrunken and widened. This board has a low entry rocker which makes catching waves a breeze. This surfboard catches waves like a fish but still surfs like a true shortboard surfboard.

Lost Sub Scorcher Details:

• 5'11 x 19.75" x 2.38"


• 30.01 Cubic Liters


• Keahana Epoxy Construction


• FCS Fins


• Best suited Waves 2-6"

Learn More

The Shred Sled is a fish design tweaked to be an all-round surfing board. It has a smooth connected feeling that is fast and flowing. Although it looks like a small wave board, the Shred Sled will surf waves up to 6ft in all conditions.

The unique outline allows a full plan shape, yet a wide round tail is positioned behind the wing to give plenty of performance and curve to fit into all types of waves. The wing allows a straighter outline in the center of the board, which provides plenty of speed down the line. The foil has plenty of volume, yet it is shaped to allow the board to sit in the wave face creating a very smooth, connected feeling. The wing breaks this connection and water flow to give response and release when you want it.

The rocker is flat in the belly, giving the board flowing speed, yet it kicks late in the nose and a little in the tail. The deep single concave in the front end of the board blends into a double vee out the tail behind the front fins.

Designed to be ridden 4-5 inches shorter and ¾ to 1 inch wider than your performance shortboard

Haydenshapes surfboard details:

• 6'4 x 20.25 x 2 5/8"


• 34.88 Cubic Litres


• Future Fins

Learn More

The world's all-time best selling fish model surfboard. During the filming of 5'5" REDUX, the RNF and RNF Quad were updated and fine tuned. The nose has gotten wider again, and more conservative overall rocker and less concave make for a board that will hold speed in flats and produce harder, longer carves.

A longer, less pronounced vee in the tail gives a more predictable feel out of turns, and a straighter outline adds drive and hold. The deep wing, influenced by MR's vintage twin fins, adds more control of high speeds and better bite in snaps and out of carves. It still paddles great, still makes you look good, but the updates allow harder, more powerful carving turns and a wider range of performance in more varied surf.

Enjoy playing with a multitude of fin setups. The RNF is designed as a twin with rear trailer, but works great as a pure twin fin or try all three standard thrusters for different feels in different conditions. ...Everyone should own one.

Lost Round Nose Fish Surfboard Details:

• 5'11 x 20.13" x 2.44"


• 34.25 Cubic Litres


• FCS 5 Fin Setup


• Red Resin Tint


• Wave Height 1-6'

Learn More

This is the Original 1997 Lost Round Nose Fish design. This Lost fish surfboard is an amazing wave catching machine that still surfs insane. Take this surfboard out in 2' slop or in slightly overhead surf.

Lost RNF Surfboard Details:

• 6'4 x 21" x 2.75"


• 41.13 Cubic Litres


• FCS/Thruster Setup (includes twin with trailer)

Learn More