The Lost Mini Driver surfboard is a great bigger wave surfboard that can be ridden shorter by a few inches than your traditional shortboard. This board has a slightly flatter rocker with a pulled in tail so it can handle the 2' slop and the macking barrels. Here is details about the surfboard as described by shaper Matt Biolos. Mini Driver – While preparing a quiver for an Indo trip Kolohe asked for “a short, fast (flat rockered) little 5 fin tube rider”. I recommended the Rock-Up, but he felt it had more tail rocker than he liked and wanted something really, really fast that he could take off extremely deep and pump through tubes from way back. We started with a 6’0” Driver, took note of the nose rocker and outline measurements at 4” and 16” back from the tip, then shrunk the board to a 5’8” and lowered the nose rocker at the tip and 12” back till it matched the 4” and 16” from before. We widened the nose until it matched up the same way. This gave us a screaming fast low nose rocker with a forward placed outline, both attributes give tons of drive. We then rounded off the tail, but left the width at 12” the same. This gave us a very clean and elliptical outline that we expected would move free and easy inside the tube. The Mini Driver performed as hoped. Interestingly enough, one of Kolohe’s buddies (Taylor Clark) grabbed it after it came back from Indo and used it in the US Nationals event in Huntington Beach. He surfed it in 2’ slop all the way to a second place finish in the Open Men’s division. The board worked in everything.

Lost Mini Driver Details:


5'8 x 19" x 2.32"

26.30 Cubic Liters

FCS Fins/5 fin setup

3-7 foot surf Learn More

The Lost Couch Potato surfboard is the extreme small wave surfboard. It is wider, shorter, and has a really flat rocker. The outline and the rocker of this board make it extremely fast, yet very controllable in gutless surf.

Lost Couch Potato details:


5'8 x 22 x 2.32

36.90 Cubic Litres

FCS 5 fin set up

1-4 foot surf Learn More

In surfboards, everything is balance. Curvy rockers need to balance with straighter outlines and curvy outlines need flatter rockers. These principles became very apparent in the development of the Pelagic. Beginning with a fairly standard RNF template, we added a point at 12” from the tail and carved a reverse, side-cut, outline from there forward, into the wide point just above center. This effectively creates a reversed curve outline between the riders stance. To balance the negative outline curve, we have added a tremendous amount of rail rocker through the center of the board. The final component is very low, straight and fast centerline rocker, which cuts a massively deep concave through the rail rocker.

Lost Pelagic Surfboard Details:

• 5'8 x 20" x 2.38"


• FCS 5-Fin


• 29.94 Cubic Liters

Learn More

Firewire 5'8 Lost Sub Scorcher

Firewire technology relies primarily on the PARABOLIC Balsa Rail to control flex while the high density aerospace composite vacuumed to both top and bottom decks provides significant impact strength, and is stronger than the traditional PU surfboard.

“I wanna board for 1′ mush. Something really short and wide, but still a short board…..something like Danes board.” –Kolohe Andino

The challenged was laid down. Starting with an old SD2: We squashed the dims to 5’5″x18.63″x 2.13″, lowered the entry rocker and shallowed the concave through the center to straighten the rail line for drive and make it easier to lay such a wide platform over on a rail. “Viola!” Our stubbiest short board yet, but it still carves like a real board. Kolohe wanted to call it “The Trashcan Lid” because you don’t need to go dumpster diving to get one of these!

Details:
Learn More

Firewire 5'8 Lost Sub Scorcher

Firewire technology relies primarily on the PARABOLIC Balsa Rail to control flex while the high density aerospace composite vacuumed to both top and bottom decks provides significant impact strength, and is stronger than the traditional PU surfboard.

“I wanna board for 1′ mush. Something really short and wide, but still a short board…..something like Danes board.” –Kolohe Andino

The challenged was laid down. Starting with an old SD2: We squashed the dims to 5’5″x18.63″x 2.13″, lowered the entry rocker and shallowed the concave through the center to straighten the rail line for drive and make it easier to lay such a wide platform over on a rail. “Viola!” Our stubbiest short board yet, but it still carves like a real board. Kolohe wanted to call it “The Trashcan Lid” because you don’t need to go dumpster diving to get one of these!

Details:
Learn More

This Lost Sub-Driver Surfboard is a great beach break surfboard that will handle small to mid sized waves. This board has a little more nose rocker and a flatter tail rocker.

Lost Sub Driver Details:

• 5'8 x 18.75" x 2.25"


• 25.63 Cubic Liters


• FCS Fins


• Keahana Epoxy construction


• Best in 2'-6' Surf

Learn More

The Lost Couch Potato surfboard is the extreme small wave surfboard. It is wider, shorter, and has a really flat rocker. The outline and the rocker of this board make it extremely fast, yet very controllable in gutless surf.

Lost Couch Potato details:

• 5'8 x 22" x 2.5"


• 36.7 Cubic Litres


• FCS Fins


• 1-4 foot surf

Learn More