The world's all-time best selling fish model surfboard. During the filming of 5'5" REDUX, the RNF and RNF Quad were updated and fine tuned. The nose has gotten wider again, and more conservative overall rocker and less concave make for a board that will hold speed in flats and produce harder, longer carves.

A longer, less pronounced vee in the tail gives a more predictable feel out of turns, and a straighter outline adds drive and hold. The deep wing, influenced by MR's vintage twin fins, adds more control of high speeds and better bite in snaps and out of carves. It still paddles great, still makes you look good, but the updates allow harder, more powerful carving turns and a wider range of performance in more varied surf.

Enjoy playing with a multitude of fin setups. The RNF is designed as a twin with rear trailer, but works great as a pure twin fin or try all three standard thrusters for different feels in different conditions. ...Everyone should own one.

Lost Round Nose Fish Surfboard Details:

• 5'11 x 20.13" x 2.44"


• 34.25 Cubic Litres


• FCS 5 Fin Setup


• Red Resin Tint


• Wave Height 1-6'

Learn More

Derived from the Whiplash-TB. The TB-Stepdown is more of an “every-mans” high performance shortboard. Used by many WT and Qualifying Series competitors, because it works equally well in small junk surf. Featuring the Same WL-TB, hyper extended tail rocker (for tight radius arcs off the back foot) but a significantly more relaxed entry rocker, which combined with a wider nose allows for more drive and forward momentum , and stability, with a bigger landing platform from reverse and tweaked airs. A wider hip and tail block is added to the outline in the tail for more lift at low speeds, but the tail width at 12” is relatively the same as the WL- TB. This allows for superior precision and control than most al other “grovel” boards. With the centerline and rail volume is carried farther into the rails….and out to nose and tail the TB-stepdown is designed to be ridden 1-2” shorter than the WLashTB. In the right size, this is a HP shortboard that can be ridden and enjoyed by most surfers.

Lost Taj Burrow Beach Buggy Details:

5'11 x 19" x 2.32"
FCS Fins
27.81 Cubic Litres Learn More

This used Rusty Fish surfboard is in great condition. This surfboard would make a great summer surfboard.

Used Surfboard Details:
5'11 x 21.2" x 2.45"
Glass on Fins
Rating (good) Learn More

This Lost Surfboard is Kolohe Andino's small wave groveling surfboard model. This surfboard is a blend of Lost's Scorcher and SD2 model shrunken and widened. This board has a low entry rocker which makes catching waves a breeze. This surfboard catches waves like a fish but still surfs like a true shortboard surfboard.

Lost Sub Scorcher Details:

• 5'11 x 19.75" x 2.38"


• 30.01 Cubic Liters


• Keahana Epoxy Construction


• FCS Fins


• Best suited Waves 2-6"

Learn More

This used 5'11 Channel Islands Remix surfboard was team rider Evan Geiselman's. This board is in good condition but has a few minor dings that could use some TLC.

Used Channel Islands Details:

5'11 x 18.25" x 2.5"
Glass on Fins
Rating (good) Learn More

The Lost Lay-Z boy surfboard is both a continuation and a break away from the Bottom Feeder and Plank Genre surfboards. The Lay-Zboy takes these high volume low rocker small wave surfboard designs and brings it to a wider range of surf capabilities. This surfboard uses an eliptical outline influenced by Wayne Lynch & Michael Peterson in the 1970's as well as Dave Parmenter in the 80's and 90's. These eliptical outlines give the Lay-Zboy a very open and forgiving sweet spot and allow the board to be surfed in knee to well overhead waves.

Lost Lay-Zboy details:
6' x 22" x 2.75"
41.74 cubic litres
Future 5 fin set up


Learn More

Lost 5'11 Pelagic Fish Surfboard:

In surfboards, everything is balance. Curvy rockers need to balance with straighter outlines and curvy outlines need flatter rockers. These principles became very apparent in the development of the Pelagic. Beginning with a fairly standard RNF template, we added a point at 12” from the tail and carved a reverse, side-cut, outline from there forward, into the wide point just above center. This effectively creates a reversed curve outline between the riders stance. To balance the negative outline curve, we have added a tremendous amount of rail rocker through the center of the board. The final component is very low, straight and fast centerline rocker, which cuts a massively deep concave through the rail rocker.

Details:

• 5'11 x 20.75 x 2.5


• Future 5-Fin


• 34.42 Cubic Liters

Learn More

This Robert's Modern 80's surfboard is a flashback to the 80's style shortboard surfboard. This board has a little more volume and is a great all around surfboard.

Roberts Modern 80's Surfboard Details:

• 5'11 x 19.75" x 2 7/16"


• Future Fins


• Waist to Overhead surf

Learn More

Lost 5'11 Pelagic Fish Surfboard:

In surfboards, everything is balance. Curvy rockers need to balance with straighter outlines and curvy outlines need flatter rockers. These principles became very apparent in the development of the Pelagic. Beginning with a fairly standard RNF template, we added a point at 12” from the tail and carved a reverse, side-cut, outline from there forward, into the wide point just above center. This effectively creates a reversed curve outline between the riders stance. To balance the negative outline curve, we have added a tremendous amount of rail rocker through the center of the board. The final component is very low, straight and fast centerline rocker, which cuts a massively deep concave through the rail rocker.

Details:

• 5'11 x 20.75 x 2.5


• FCS 5-Fin


• 34.42 Cubic Liters

Learn More

This used Hoyte surfboard is in great condition and has an asymmetrical tail. This surfboard is a super fast wave machine.

Used Surfboard Details:
5'11 x 20.25" x 2 5/8"
Glass On Fins
Rating (good) Learn More